- 您现在的位置：买卖IC网 > Sheet目录337 > LT3743EFE#PBF (Linear Technology)IC LED DVR HP CONST CURR 28TSSOP
LT3743
PIN FUNCTIONS
(QFN/TSSOP)
GND (Pins 1, 5, 9, 20, 21, Exposed Pad Pin 29/Pins 2, 7,
11, 22, 27, Exposed Pad Pin 29): Ground. The exposed
pad must be soldered to the PCB.
EN/UVLO (Pin 2/Pin 4): Enable Pin. The EN/UVLO pin
acts as an enable pin and turns on the internal current
bias core and subregulators at 1.55V. The pin does
not have any pull-up or pull-down, requiring a voltage
bias for normal part operation. Full shutdown occurs at
approximately 0.5V.
V REF (Pin 3/Pin 5): Buffered 2V Reference Capable of
0.5mA Drive.
CTRL_T (Pin 4/Pin 6): The thermal control input to reduce
the regulated current level for both current levels (CTRL_L
and CTRL_H).
CTRL_H (Pin 6/Pin 8): The CTRL_H pin sets the high level
regulated output current and overcurrent. The maximum
input voltage is internally clamped to 1.5V. The overcurrent
set point is equal to the high level regulated current level
set by the CTRL_H pin with an additional 23mV offset
between the SENSE + and SENSE – pins.
CTRL_L (Pin 7/Pin 9): The CTRL_L pin sets the low level
regulated output current. It is not recommended that the
CTRL_L voltage be higher than the CTRL_H voltage.
SS (Pin 8/Pin 10): Soft-Start Pin. Place an external capacitor
to ground to limit the regulated current during start-up
conditions. The SS pin has a 5.5μA charging current. This
pin controls both of the regulated inputs determined by
CTRL_L and CTRL_H.
FB (Pin 10/Pin 12): Feedback Pin for Overvoltage Protec-
tion. The feedback voltage is 1V. Overvoltage/Open LED
is sensed through the FB pin. When the feedback voltage
exceeds 1.3V, the overvoltage lockout prevents switch-
ing and connects both output capacitors to discharge the
inductor current.
SENSE + (Pin 11/Pin 13): SENSE + is the inverting input of
the average current mode loop error amplifier. This pin is
connected to the external current sense resistor, R S . The
voltage drop between SENSE + and SENSE – referenced to
the voltage drop across an internal resistor produces the
input voltages to the current regulation loop.
SENSE – (Pin 12/Pin 14): SENSE – is the noninverting input
of the average current mode loop error amplifier. The
reference current, based on CTRL_L or CTRL_H flows out
of the pin to the output (LED) side of the sense resistor, R S .
V CL (Pin 13/Pin 15): V CL provides the necessary compensa-
tion for the average current loop stability during low level
current regulation. Typical compensation values are 15k
to 80k for the resistor and 2nF to 10nF for the capacitor.
V CH (Pin 14/Pin 16): V CH provides the necessary compen-
sation for the average current loop stability during high level
current regulation. Typical compensation values are 15k
to 80k for the resistor and 2nF to 10nF for the capacitor.
RT (Pin 15/Pin 17): A resistor to ground sets the switching
frequency between 200kHz and 1MHz. When using the
SYNC function, set the frequency to be 20% lower than
the SYNC pulse frequency. This pin is current limited to
60μA. Do not leave this pin open.
SYNC (Pin 16/Pin 18): Frequency Synchronization Pin.
This pin allows the switching frequency to be synchronized
to an external clock. The R T resistor should be chosen to
operate the internal clock at 20% slower than the SYNC
pulse frequency. The synchronization range is 240kHz to
1.2MHz. This pin should be grounded when not in use.
CTRL_SEL (Pin 17/Pin 19): The CTRL_SEL pin selects
between the high current control, CTRL_H and the low
current control, CTRL_L. When high, the V CH pin is con-
nected to the error amp output and the PWMGH gate
signal is high. When low, the V CL pin is connected to the
error amp output and the PWMGL gate signal is high. This
pin is used for current level dimming of the LED. This pin
should be grounded when not in use.
PWM (Pin 18/Pin 20): The input pin for PWM dimming
of the LED. When low, all switching is terminated and the
output caps are disconnected. This pin should be pulled
to V CC_INT when not in use.
PWMGH (Pin 19/Pin 21): The PWMGH output pin drives
the gate of an external FET to connect one of the switching
regulator output capacitors to the load. The driver pull-up
impedance is 3.2Ω and pull-down impedance is 1.75Ω.
3743fd
9
发布紧急采购，3分钟左右您将得到回复。
相关PDF资料
LT3745IUJ#TRPBF
IC LED DVR 16CH 50MA 40QFN
LT3746IUHH#TRPBF
IC LED DRIVER 32CHANNEL 56-QFN
LT3754IUH#TRPBF
IC LED DVR 16CH 50MA 32QFN
LT3755EMSE#PBF
IC LED DRVR HP CONS CURR 16-MSOP
LT3760EFE#PBF
IC LED DVR WHT/CLR BCKLT 28TSSOP
LT3799IMSE#PBF
IC LED DRIVER TRIAC DIM 16-MSOP
LT3956EUHE#PBF
IC LED DVR BUCK BOOST 36-VQFN
LTC3201EMS#TRPBF
IC LED DRVR WHITE BCKLGT 10-MSOP
相关代理商/技术参数
LT3743EFE#PBF
制造商:Linear Technology 功能描述:IC LED DRIVER BUCK TSSOP-28
LT3743EFE#TRPBF
功能描述:IC LED DVR SYNC STEPDOWN 28TSSOP RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LT3743EFEPBF
制造商:LINER 制造商全称:Linear Technology 功能描述:High Current Synchronous Step-Down LED Driver with Three-State Control
LT3743EFETRPBF
制造商:LINER 制造商全称:Linear Technology 功能描述:High Current Synchronous Step-Down LED Driver with Three-State Control
LT3743EUFD#PBF
功能描述:IC LED DRVR HP CONST CURR 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 产品培训模块:Lead (SnPb) Finish for COTS
Obsolescence Mitigation Program 标准包装:2,500 系列:- 恒定电流:- 恒定电压:- 拓扑:升压（升压），切换式电容器（充电泵） 输出数:1 内部驱动器:是 类型 - 主要:背光 类型 - 次要:白色 LED 频率:625kHz ~ 875kHz 电源电压:2.7 V ~ 5.3 V 输出电压:5V 安装类型:表面贴装 封装/外壳:10-TFSOP，10-MSOP（0.118"，3.00mm 宽） 供应商设备封装:10-µMAX 包装:带卷 (TR) 工作温度:-40°C ~ 85°C
LT3743EUFD#PBF
制造商:Linear Technology 功能描述:IC LED DRIVER BUCK QFN-28 制造商:Linear Technology 功能描述:IC, LED DRIVER, BUCK, QFN-28
LT3743EUFD#TRPBF
功能描述:IC LED DVR SYNC STEP-DOWN 28QFN RoHS:是 类别:集成电路 (IC) >> PMIC - LED 驱动器 系列:- 标准包装:6,000 系列:- 恒定电流:- 恒定电压:- 拓扑:开路漏极，PWM 输出数:4 内部驱动器:是 类型 - 主要:LED 闪烁器 类型 - 次要:- 频率:400kHz 电源电压:2.3 V ~ 5.5 V 输出电压:- 安装类型:表面贴装 封装/外壳:8-VFDFN 裸露焊盘 供应商设备封装:8-HVSON 包装:带卷 (TR) 工作温度:-40°C ~ 85°C 其它名称:935286881118PCA9553TK/02-TPCA9553TK/02-T-ND
LT3743EUFDPBF
制造商:LINER 制造商全称:Linear Technology 功能描述:High Current Synchronous Step-Down LED Driver with Three-State Control